THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Rethreading barrels
 Login/Join
 
One of Us
posted
Hello
Can you rethread a Remington or Winchester barrels to fit a Largering or smallring Mauser?

If you can, are there anybody here that can do it and what would it cost?
 
Posts: 344 | Location: Elkin North Carolina USA | Registered: 12 March 2006Reply With Quote
one of us
Picture of D Humbarger
posted Hide Post
Yes to both but doing it for a large ring much more work. (threaded sleeve)



Doug Humbarger
NRA Life member
Tonkin Gulf Yacht Club 72'73.
Yankee Station

Try to look unimportant. Your enemy might be low on ammo.
 
Posts: 8351 | Location: Jennings Louisiana, Arkansas by way of Alabama by way of South Carloina by way of County Antrim Irland by way of Lanarkshire Scotland. | Registered: 02 November 2001Reply With Quote
Moderator
Picture of jeffeosso
posted Hide Post
remiturks abound

cut the shank off and rethread works, too


opinions vary band of bubbas and STC hunting Club

Information on Ammoguide about
the416AR, 458AR, 470AR, 500AR
What is an AR round? Case Drawings 416-458-470AR and 500AR.
476AR,
http://www.weaponsmith.com
 
Posts: 40081 | Location: Conroe, TX | Registered: 01 June 2002Reply With Quote
One of Us
posted Hide Post
Since we're on the subject, can a LR 98 barrel be rethreaded to fit a '91 Argentine action? I have a nice take off in 7x57 that I might use on the '91 if it's doable.
 
Posts: 8169 | Location: humboldt | Registered: 10 April 2002Reply With Quote
One of Us
posted Hide Post
Jeffeosso
Do you mean this can be done for a largering or smallrng?

Can somebody on the forum do this and what would it cost


Can this be done with a Remington or Winchester barrel?
 
Posts: 344 | Location: Elkin North Carolina USA | Registered: 12 March 2006Reply With Quote
One of Us
posted Hide Post
Check my response on 24 hr. OH OH, I let the cat out of the bag. Really guys, the only reason I went over there was to see what 22wrf was selling, HONEST!


Jim Kobe
10841 Oxborough Ave So
Bloomington MN 55437
952.884.6031
Professional member American Custom Gunmakers Guild

 
Posts: 5534 | Location: Minnesota | Registered: 10 July 2002Reply With Quote
Moderator
Picture of jeffeosso
posted Hide Post
as long as your gunsmith is comfortable with the barrel profile, and you have at LEAST 1.1" in diameter, it will work for both.


opinions vary band of bubbas and STC hunting Club

Information on Ammoguide about
the416AR, 458AR, 470AR, 500AR
What is an AR round? Case Drawings 416-458-470AR and 500AR.
476AR,
http://www.weaponsmith.com
 
Posts: 40081 | Location: Conroe, TX | Registered: 01 June 2002Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia