THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Modifying the follower
 Login/Join
 
One of Us
Picture of Snellstrom
posted
On my Husky the magazine follower has an abrupt edge that stops the bolt when no rounds are present. Can I just grind or file this to an angle so it will allow the bolt to close? or am I missing something bigger?
 
Posts: 5604 | Location: Eastern plains of Colorado | Registered: 31 October 2005Reply With Quote
One of Us
posted Hide Post
Snellstrom,

No problem. That's what is customarily done!
 
Posts: 1610 | Location: Shelby, Ohio | Registered: 03 November 2005Reply With Quote
Moderator
Picture of jeffeosso
posted Hide Post
about 30 degrees...

a belt sander will make this far easier, as followers can range, in hardness, from tin to woodpecker lips to lawyer's hearts

jeffe


opinions vary band of bubbas and STC hunting Club

Information on Ammoguide about
the416AR, 458AR, 470AR, 500AR
What is an AR round? Case Drawings 416-458-470AR and 500AR.
476AR,
http://www.weaponsmith.com
 
Posts: 40106 | Location: Conroe, TX | Registered: 01 June 2002Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia