This is the action that Ralph Martini will use on the 458 Lott he is making for me.The original safety will be replaced with a three position safety.What do you think?[URL= ]Vector1[/URL] [URL= ]Vector2[/URL] [URL= ]Vector3[/URL] [URL= ]Vector4[/URL] Isn't she a beauty? A south african babe!
Posts: 11651 | Location: Montreal | Registered: 07 November 2002
Ive seen vectors that had excessive error [taper]in the receivers bored bolt hole, and that also required alot of general truing,...however i am extremely confident Ralf would have soundly assessed your receiver before deciding to incorporate it into an rifle build,-good luck.
Posts: 9434 | Location: Here & There- | Registered: 14 May 2008
If you are not scoping it, I would leave the safety as is. Good luck with the project. I was ready to have Ralf start a gun but got side tracked by two double rifles. He is the man!!!
Posts: 3073 | Location: Pittsburgh, PA | Registered: 11 November 2004
Shootaway, nice action. Having both the original mauser flag safety on an original magnum mauser, and a three position side safety on an '09 Argentinian action, I think my next one will probably be one of the two position ones (can't remember the name) that retains the original bolt shroud but easier to use with a scope than the flag type. I like the look of the mauser shroud. Keep us informed, with pictures, of the progress with this please. Good luck, Chris
DRSS
Posts: 1994 | Location: Australia | Registered: 25 December 2006
]Vector1[/URL] [URL=
]Vector2[/URL] [URL=
]Vector3[/URL] [URL=
]Vector4[/URL] Isn't she a beauty? A south african babe!
