Bear,

Others may ask...Is that a fixed or removable brake? Or can it be had either way?

BigBores I use 11/16x24 tpi or 3/4x24 tpi for .50 caliber. I'll use 7/8x24 for the 60 & 70 cal that I wager is on the horizon.

[ 08-15-2002, 23:29: Message edited by: Bear Claw ]

Bear Claw,

Can you make that brake the same diameter as the barrel? These .620 barrels will be 1.00 at the muzzle.

Yes sir thats a piece of cake.

Good looking break Bear Claw. The break I have had made for my .585 has 70x3mm holes angled 20 degrees forward in an attempt to adress the noise issue. A couple of people on this forum have said that the holes are to small, I tend to agree but I will wait & see how it works as it is removeable with thread cap. I might have to get one off you in the future for my .585.