THE ACCURATERELOADING.COM MEDIUM BORE RIFLE FORUM


Moderators: Paul H
Go
New
Find
Notify
Tools
Reply
  
Re: "one side" or "two side"?
 Login/Join
 
carcano91
one of us
posted
Quote:

Thanks for your reply. Does CIP specifications indicate if the shoulder angle you report (~35 degrees) is "one side" or a "two side" measurement(single angle using both shoulders with a converging point somewhere in the case neck/throat area)?



Double angle.

Regards,
Carcano
 
Posts: 2452 | Location: Old Europe | Registered: 23 June 2001Reply With Quote
D Humbarger
one of us
Picture of D Humbarger
posted Hide Post
I had bought a new set of RCBS 9.3x62 dies but it seemed that they were made to use 30-06 cases as my Norma virgin 9.3 cases were too tight a fit in the RCBS dies. I sold the RCBS dies & bought a set of Reddings which must be made to use 9.3 brass because the fit was perfect & I am completely satisfied! Just my experience for whats it worth.
 
Posts: 8355 | Location: Jennings Louisiana, Arkansas by way of Alabama by way of South Carloina by way of County Antrim Irland by way of Lanarkshire Scotland. | Registered: 02 November 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2025 Accuratereloading.com


Visit our on-line store for AR Memorabilia