The Accurate Reloading Forums
Re: "one side" or "two side"?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/3221043/m/47010367

24 October 2004, 23:28
carcano91
Re: "one side" or "two side"?
Quote:

Thanks for your reply. Does CIP specifications indicate if the shoulder angle you report (~35 degrees) is "one side" or a "two side" measurement(single angle using both shoulders with a converging point somewhere in the case neck/throat area)?



Double angle.

Regards,
Carcano
24 October 2004, 10:45
D Humbarger
I had bought a new set of RCBS 9.3x62 dies but it seemed that they were made to use 30-06 cases as my Norma virgin 9.3 cases were too tight a fit in the RCBS dies. I sold the RCBS dies & bought a set of Reddings which must be made to use 9.3 brass because the fit was perfect & I am completely satisfied! Just my experience for whats it worth.