One of Us
| I sue standard 308/30-06 size ones; yours must be a tight one; the 9.3 is slightly bigger in the base. |
| | |
One of Us
| call RCBS and ask them..... (800) 379-1732
///////////////////////////////////////////////////////////////////////////
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery."
Winston Churchill
|
| | | Posts: 28849 | Location: western Nebraska | Registered: 27 May 2003 | 
IP
|
|
One of Us
| You will find it on their website. Also list some nitro cartridges not easy to find listed alsewhere. Cheers, Chris
DRSS
|
| | | Posts: 2035 | Location: Australia | Registered: 25 December 2006 |
IP
|
|
One of Us
| What cases are you using. Lapua & Norma cases will work with standard 308 / 30'06 shell holders. It is possible that you might have issues with other European brass like Privi ???
"When the wind stops....start rowing. When the wind starts, get the sail up quick."
|
| | |
one of us
| RCBS lists the # 3 shellholder as the correct shellholder for the 9.3x62 along with all 30-06 based cartridges. I have used several European made brands of brass that seemed slightly oversized and very tight in the # 3 shellholder. Using the RCBS # 2 shellholder which is recommended for the 6.5x55 cartridge solves that problem. |
| | | Posts: 2460 | Location: manitoba canada | Registered: 01 March 2001 |
IP
|
|
one of us
| The problem is likely in the width of the extractor groove rather than in the diameter of the case head. You will often find a narrower extractor groove on some European brass. The solution would be to mill (or simply grind) just a tad off of the face of the shellholder to make its rim engagement a bit thinner. |
| | | Posts: 13339 | Location: Henly, TX, USA | Registered: 04 April 2001 |
IP
|
|
One of Us
| I have only Privi brass and it works with standard shell holders. |
| | |
