THE ACCURATERELOADING.COM GUNSMITHING FORUM

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Gunsmithing    Point of imact change - 150 to 200 grains in 308?

Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Point of imact change - 150 to 200 grains in 308?
 Login/Join
 
One of Us
posted
What degree of change in windage or elevation is considered normal for 308 Winchester class of ammunition when sporting ammunition bullet weights are changed from approximately 150 to 200 grains? The question pertains to likelihood of using the same point of aim for acceptable "hunting" accuracy up to 150 yards.


It's so simple to be wise. Just think of something stupid to say and then don't say it. Sam Levinson
 
Posts: 1520 | Location: Seeley Lake | Registered: 21 November 2007Reply With Quote
One of Us
Picture of bluefish
posted Hide Post
I’d bet at least an inch of elevation.
 
Posts: 5232 | Location: The way life should be | Registered: 24 May 2012Reply With Quote
one of us
posted Hide Post
Any where from dam they both shoot tiny little groups together.

To I can not hit the broad side of a barn using one over the other.

Just go shoot the rifle and find out.
 
Posts: 19710 | Location: wis | Registered: 21 April 2001Reply With Quote
one of us
posted Hide Post
That's been my experience too. I regularly sight in rifles for customers. Sometimes I will take up to 4 brands of ammo in different bullet styles and weights. They can print all over the place, and not just vertically. I will say that the most consistent are old cup and core bullets. Pick the same design in the two bullet weights. Don't mix Spire Point, Round Nosed, or Ballistic tip.

quote:
Originally posted by p dog shooter:
Any where from dam they both shoot tiny little groups together.

To I can not hit the broad side of a barn using one over the other.

Just go shoot the rifle and find out.
 
Posts: 3827 | Location: SC,USA | Registered: 07 March 2002Reply With Quote
One of Us
Picture of dpcd
posted Hide Post
150 yards is well within Point Blank Range for any cartridge in the 308 category and faster. And for many others too.
 
Posts: 17373 | Location: USA | Registered: 02 August 2009Reply With Quote
Moderator
Picture of jeffeosso
posted Hide Post
quote:
Originally posted by dpcd:
150 yards is well within Point Blank Range for any cartridge in the 308 category and faster. And for many others too.


30-30 too


opinions vary band of bubbas and STC hunting Club

Information on Ammoguide about
the416AR, 458AR, 470AR, 500AR
What is an AR round? Case Drawings 416-458-470AR and 500AR.
476AR,
http://www.weaponsmith.com
 
Posts: 40030 | Location: Conroe, TX | Registered: 01 June 2002Reply With Quote
one of us
posted Hide Post
quote:
Originally posted by dpcd:
150 yards is well within Point Blank Range for any cartridge in the 308 category and faster. And for many others too.


That doesn't mean they well shoot to the same point of aim. Or group together.
 
Posts: 19710 | Location: wis | Registered: 21 April 2001Reply With Quote
one of us
posted Hide Post
Go to the range and test your rifle Thats the only real way to know, they rest is guess and by gosh, not fact..


Ray Atkinson
Atkinson Hunting Adventures
10 Ward Lane,
Filer, Idaho, 83328
208-731-4120

rayatkinsonhunting@gmail.com
 
Posts: 42210 | Location: Twin Falls, Idaho | Registered: 04 June 2000Reply With Quote
one of us
posted Hide Post
Counterintuitively, the slower bullet often prints higher on the target. This is due to a number of factors, among which is longer barrel time, thus the recoil of the rifle has time to lift the muzzle slightly, therefore changing the point of impact. This is usually minimal with rifles, but significant and obvious with handguns.

However, muzzle oscillations can counter or enhance differences in velocities, so it is impossible to accurately predict just how much differently two different weights (or even two bullets of the same weight) will group.

As has been suggested, the only way to know is to the shoot groups with the rifle with the exact two loads in question and see what happens.
 
Posts: 13263 | Location: Henly, TX, USA | Registered: 04 April 2001Reply With Quote
  Powered by Social Strata  
 

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Gunsmithing    Point of imact change - 150 to 200 grains in 308?

Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia