THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
extractor rotation (mauser)
 Login/Join
 
One of Us
Picture of richj
posted
I noticed an interesting problem on my Daly (Mark X) 300 Winmag the last time I was at the range. The feeding was a bit hard and the front/top of the extractor was hitting the back of the front receiver ring. I swapped out the extractor with a spare that had a lot LESS metal but still held the round to the bolt. Feeding smoothed out quite a bit. I'll shoot it tomorrow. I'm going to compare the original to my 270 to see if they are the same. I'm guessing they should NOT be.

Rich
 
Posts: 6529 | Location: NY, NY | Registered: 28 November 2005Reply With Quote
Moderator
Picture of jeffeosso
posted Hide Post
try whiteout to see where its rubbing


opinions vary band of bubbas and STC hunting Club

Information on Ammoguide about
the416AR, 458AR, 470AR, 500AR
What is an AR round? Case Drawings 416-458-470AR and 500AR.
476AR,
http://www.weaponsmith.com
 
Posts: 40106 | Location: Conroe, TX | Registered: 01 June 2002Reply With Quote
One of Us
Picture of richj
posted Hide Post
Jeff

I can see where it's hitting. Not sure I want to grind anything. I think the angle of the hook is causing the rotation. I'll get pics.

with the replaced extractor the cases jump onto the bolt with the old one they stay in the mag longer.

Rich
 
Posts: 6529 | Location: NY, NY | Registered: 28 November 2005Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia