Can some one here make me some steel tube ? I need an inside Dia of .187" and an outside Dia of .250" X 4" long, two of them ? Any one up to this ?

4" is a long ways to run a 3/16" drill but It can be done. You didn't say where you live but the best way is to go to a steel center and ask for a length of 1/4" X 1/32 wall BWMD or DOM tubing.
Also try hydraulic shops that have hydraulic tubing.

This is for my RC truck I have, I make custom length drive shafts out of alum tube but the truck just twisted a shaft real bad, so I need to go with steel, let me see what I can find around here. Thanks.

The pic here is of the steel shafts cut in half so I can insert them in a tube, the botom is of my saft I made out of alum tube and it just was not strong enough !!

Try Small Parts Inc...they have tons of tubing in just about any material and any size you could want.

Pre-hard 4140 tubing is avail. from Aircraft Spruce and Specialities and Nolan Supply (both have websites). Drilling to the center of a 4" long piece of steel should not be much of a problem if one uses a lathe, center drill and new, sharp drill. I'd drill from each end, face to length before starting to drill.