THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Replaced the stock and.....
 Login/Join
 
One of Us
Picture of smedley
posted
....I would like to secure the action right.

This is an H-S carbon/kevlar with aluminum bedding block for an early 70's M70 standard action. It is two piece lower metal.
H-S gave me new screws and an epoxy mix but, no instructions on which screws to tighten in which order or how many in.lbs. each should be.

Thanks Folks!!!


______________________

Smedley

______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
 
Posts: 3242 | Location: Cruising through the Milky Way at 98,000fps | Registered: 03 October 2005Reply With Quote
One of Us
posted Hide Post
60 to 65 inch pounds should do the trick . Be consistant each time you put the gun back together. Even then your POI might be off slightly. What did the stock set you back?
Wayles
 
Posts: 57 | Location: western nebraska | Registered: 04 February 2006Reply With Quote
One of Us
Picture of smedley
posted Hide Post
Not quite $400 with shipping and paint. (it did take a while to get though)

Is there a sequence I should do this or all three evenly?


______________________

Smedley

______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
 
Posts: 3242 | Location: Cruising through the Milky Way at 98,000fps | Registered: 03 October 2005Reply With Quote
one of us
Picture of dempsey
posted Hide Post
The middle screw should barely be hand tight. I'd ditch the two piece all together and get a one piece that'll eliminate the middle screw.


______________________
Always remember you're
unique, just like everyone else.

 
Posts: 6205 | Location: Cascade, MT | Registered: 12 February 2002Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia