The Accurate Reloading Forums
Replaced the stock and.....

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/475106616

04 February 2007, 01:30
smedley
Replaced the stock and.....
....I would like to secure the action right.

This is an H-S carbon/kevlar with aluminum bedding block for an early 70's M70 standard action. It is two piece lower metal.
H-S gave me new screws and an epoxy mix but, no instructions on which screws to tighten in which order or how many in.lbs. each should be.

Thanks Folks!!!


______________________

Smedley

______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
04 February 2007, 03:15
wayles
60 to 65 inch pounds should do the trick . Be consistant each time you put the gun back together. Even then your POI might be off slightly. What did the stock set you back?
Wayles
04 February 2007, 03:48
smedley
Not quite $400 with shipping and paint. (it did take a while to get though)

Is there a sequence I should do this or all three evenly?


______________________

Smedley

______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
04 February 2007, 07:11
dempsey
The middle screw should barely be hand tight. I'd ditch the two piece all together and get a one piece that'll eliminate the middle screw.


______________________
Always remember you're
unique, just like everyone else.