Well after a couple years of saving my pennies, I've finally ordered a new lathe and mill....

It's going to be so nice to use "modern" equipment for a change!

The old South Bend and Bridgeport are sold and the new owner will be pickin them up a day or two before the new state of the art stuff gets here.

It's a big investment, but it'll help me get work out much faster and without near as much setup time.

Just had to share!

Best of luck with them....new toys of any type always get me antsy.

Gary

Awesome!!
what ya get?
jeffe

I bought a Clausing 13x40 Tool Room lathe with DRO and a taper attachment.... and a Bridgeport Knee mill with a 9x32" table with DRO and power feeds

The mill is CNC ready, but that'll be a later upgrade...

Nice... Good on YOU!!
jeffe

Strong work man, strong work.

LD

Steve,
where did you get your mill and lathe? I am looking to upgrade my SouthBend lathe and Jet mill/drill.
Thanks, Bill