Standard Marine sniper rifle, 40-x leupold mark IV 308 Win. mcMillan stock

Military sniper scopes are not 40X! The scopes are 10X, and I believe that is an Unertl, not a leupy.

I think that he means that it's a 40X Remington action. - Dan

Those are .50 cal rifles. Look at the mag box.

Jordan

Have to agree with Jordan look at the muzzle brake also and the ammo at his elbow.The actual gun is a barrett 82A1 I think???

[ 03-27-2003, 07:58: Message edited by: Reloader 1 ]

We're looking at 2 different photos of 2 different guns here. A rem. based sniper rifle and a barett .50

In the original picture, I hope the guy whose shoulder the gun is resting on is wearing GOOD ear protection!
Peter.

Notice the guys shooting the M82's are only wearing earplugs. Ouch! Yes, those are M82's, the one in the forground is the current military version.

My eyes have been bloodshot for a long time but isn't that magazine a wee bit big for a .308, and why flute a .308 barrel and why is the muzzle brake so big for a .308?

Manufacturer: Specially trained armorers at Quantico, Virginia.
Length: 44 inches (111.76 centimeters)
Barrel length: 24 inches (61 centimeters)
Weight: 14.5 pounds (6.58 kilograms)
Bore diameter: 7.62mm (.308 inches)
Maximum effective range: 1000 yards (914 meters)
Muzzle velocity: 2550 feet (777 meters) per second
Chamber pressure: 50,000 psi
Magazine capacity: 5 rounds
Unit Replacement Cost: $2,105

Features: The M40A1 sniper rifle is based on the Remington model 700. It is a heavy barrel, bolt action, magazine fed 7.62mm rifle that is optimized for accuracy with Match Grade ammunition. The rifle is equipped with a special 10 power Unertl sniper scope. With scope, the rifle weighs approximately 14.5 pounds. It is equipped with a built-in five round magazine. This weapon is hand-made by specially trained and qualified armorers at Quantico, Virginia.
The unique characteristics of the M40A1 Sniper Rifle are: commercial competition-grade heavy barrel, McMillan fiberglass stock and butt pad, modified Winchester Model 70 floor plate and trigger guard, and modified and lightened trigger. In addition, each stock is epoxy bedded for accuracy and all weapons must shoot less than one minute of angle (MOA).

Background: The M40A1 was put into service in the 1970s to meet the need of a long range sniper rifle. Each rifle is hand built by specially trained and qualified personnel at the Marine Corps Marksmanship Training Unit (MTU) at Quantico, Virginia.




[ 03-28-2003, 05:18: Message edited by: DMCI* ]

It's so obvious... it's an 88 magnum Graham-Chapmin , with a "5willgetya10" X-ray vision scope.

In truth.. a line borrowed from the sad, long past and short lived Chris Elliot TV show, "Get a life." He said it about some weapon, to which Brain Doyle Murry responded.. "Well kid, ya sure know your weapons!"

WOW! someone else who'll not only admit to the existance of, but also to watching "Get A Life".

Remember the one show where there was some toxic waste disaster and it turned Elliot into a geniuos?

[ 03-29-2003, 07:58: Message edited by: Curtis_Lemay ]

They put all that work into it and all they require is MOA accuracy? Am I missing something here? I can get that kind of accuracy out of a Savage rifle right out of the box, I would expect alot better than that for our troops.

"It's a 50." DUH!!!!!