Pretty slick looking...

http://www.dailymail.co.uk/sci...never-stall-air.html

Hmmm. Now where did I put those lottery tickets?

Apparently if you want to be Batman you need a batwallet.

The list of like planes goes on and on

Prescott pusher
Cozy
Velocity
Raptor
And at least 10 others .. the raptor shares several of this design's inherent short comings

Turbo 350.. wrong answer. Short engine life when run at high rpm for all car motors.

Unproven engine with known failure rates

No backup gages.. I am a computer dude. I don't trust them

Must have a speed brake. MUST have, not should have

Factory spec build only, even with kit purchase

Lots of hype no facts on website


No data on prsu. Therefore totally suspect

V tail? Really?

Good ideas
3 blade. A 5 would be better for a pusher due to smaller diameter

Full retract in a "normal" stance
. Canards are notorious for aft heavy on the ground

Far forward seating. Great for cg


Cost is way too much for concept plane


One can build an all alum 427 ford with a 1:1 prsu that makes 250 to 300 hp. The later if you are willing to run 3000 rpm. Been proven a million times. Prsu to take p factor thrust

And with ground adjustable prop, would weigh less than in io540, really

My mistake. Not turbo 350 motor. It's a tiso550 ..

Heavy but a good engine. But a Non turbo would be less maintenance and cost