Go | New | Find | Notify | Tools | Reply |
one of us |
I have just put together a 22-250 AI with a 1 in 8 twist border barrel. Does anyone have a similar tool and any recommended loads for this twist rate. I intend to use heavier bullets for longer range varminting in England. The rifle is giving .3 moa groups with fireform loads of 34g vit 140 under a 60 g sierra hollowpoint.Tragectory at the moment is disapointing with this load. Ideas please? | ||
|
one of us |
That ought to be awesome with the 68 or 69er's, or 75 A-Max at long-range. I believe there's been something in Varmint Hunter mag. about it (800-528-4868). Should be able to use 220 Swift loading data for it, but you'd better check on that. If i'm right about it John Antanies has definitely had some info. on a 220 Swift using the 75 A-Max in VH. | |||
|
one of us |
I use a 1-9 twist and load 42 grains of RL 19 behind a 75 grain amax. Works quite well for me. Pecos | |||
|
new member |
Dear Andy Mass, Why bother? I know of a chap who has an old sako smokepole far less fancy than yours, shoots v flat out to 350yd too! I believe his cost �190 but was only in normal .22/250 go figure!!! Have a nice day! | |||
|
one of us |
SR as you will no doubt be aware, your smokepole sako does shoot - a little, however, it is not a bespoke item built my AJM Custom Rifles and is not in the same league as your peashooter.Perhaps a challenge is laid down? AM | |||
|
new member |
Andy, You asked if anyone had something similar, how about an AI .220 Swift? In a 30" 1:7 Border, it uses 44grs of N560 to push 90gr JLKs at 3,350 and 46grs of N165 to push 80gr Bergers at 3,500fps+. Scaling back the charges accordingly to suit your AI 22-250 should give you velocities maybe 150fps less. Your 1:8 may not suit the 90grs JLKs tho'. Try it in F-class sometime. Cheers, Des. | |||
|
one of us |
Thanks, the 220 AI sounds very interesting, it wasn't built by a very nice chap from Parton Castle Douglas,was it? I have just recieved Redding S Dies through post so am now able to start proper load development. I will be using 80g A max and Berger vlds to start off. Do you have any problems with bullet fragmentation thru over spin at these velocities, I have heard that 1-7 can be a tad quick? | |||
|
one of us |
It should read 75g Amax - before anyone points out my deliberate mistake! | |||
|
Powered by Social Strata |
Please Wait. Your request is being processed... |
Visit our on-line store for AR Memorabilia