THE ACCURATERELOADING.COM FAVORITE LOADS FORUM


Moderators: Saeed
Go
New
Find
Notify
Tools
Reply
  
Weatherby loads
 Login/Join
 
one of us
posted
I would like to hear of your favorite loads in the .270 and 7mm Weatherby's.
 
Posts: 507 | Location: Rogersville ,tn,usa | Registered: 06 August 2001Reply With Quote
one of us
posted Hide Post
My favorite load for my Remington 700 Classic chambered for the 7mm Weatherby Magnum is as follows:

Remington brass
Federal 215M primer
IMR 7828 powder 72.5 grains
Nosler 160 grain Partition
Over all length 3.46 inches
velocity 3174 fps

Hope this helps, R F
 
Posts: 1220 | Location: Hanford, CA, USA | Registered: 12 November 2000Reply With Quote
one of us
posted Hide Post
BTT, as I've just started loading for my 270 WBY and I'm curious what people are using. - Dan
 
Posts: 5284 | Location: Alberta | Registered: 05 October 2001Reply With Quote
new member
posted Hide Post
74 grains of IMR 7828 behind a 140 grain Hornady. velocity 3400 fps.
 
Posts: 2 | Location: Alberta | Registered: 16 December 2005Reply With Quote
one of us
posted Hide Post
I used RL 22 behind the 130 grain nosler parttions for a few years with very good success. Unfortunately my second lot of RL 22 was quite a bit faster and more temperature sensative than the first lot. I've just finished two pounds of RL 25 behind the 150 grain nosler partitions with very good success. I've been using 73 grains of the RL 25. I worked up to 75 grains with good results and no obvious pressure issues at about 50 degres F. However it did show about an 80 fps variation from 30 deg. F to 70 deg. F, and as my hunting can vary from a 70 deg. New Mexico Elk hunt to a -15 degree Quebec Caribou hunt, I decided to back it down a bit. If I had any pressure data at all for the RL 25 in this cartridge I might be tempted to push it a bit more.

I really wish some of the powder and bullet companies would lay off the short maggies for a bit and catch up on the data developement using the newer powders in the .270 WBY. RL 25 and Retumbo seem like they might be really good choices. But, generally speaking with the data that is available, 7828 is probably the most useful powder.
BD
 
Posts: 163 | Location: Greenville, Maine | Registered: 25 December 2002Reply With Quote
one of us
posted Hide Post
I put a 270 Wby together last winter on a Mauser 98 action.Wby cases,CCI250 primers 73 grs 7828 and 130 gr Barnes TSX's. This is max in this rifle and it shoots under an inch at 200 yds.
 
Posts: 2436 | Location: manitoba canada | Registered: 01 March 2001Reply With Quote
one of us
posted Hide Post
I've just returned from a trip downriver. I picked up a fresh pound of 7828, but the closest I could get to a pound of Retumbo was one of those "experimental" packs with four 4 ounce little containers of 4350, 4831, H1000 and Retumbo. Any hints on retumbo in the .270 WBY would be appreciated. BD
 
Posts: 163 | Location: Greenville, Maine | Registered: 25 December 2002Reply With Quote
One of Us
posted Hide Post
Just recently tried 60.2 gr IMR 4350 under 154 gr. Hornady interbonds. Federal Gold medal 215 primers. Velocity is listed at 2900 or 3000 I beleive. Did really good on my elk this weekend.

7mm. guy


shoot straight or shoot often.
 
Posts: 277 | Registered: 18 March 2005Reply With Quote
one of us
Picture of Canadian reloarder
posted Hide Post
I have Md 70 Win chambered for the 270 Weath. I have found that H 450 to be the best allround powder if you can still find some. With max loads I have gotten well over 3300ft/sec with the 130gr Hornady, and 3210ft/sec with the 150 Hornady.


"300 Win mag loaded with a 250 gr Barnes made a good deer load". Elmer Keith
 
Posts: 172 | Location: Canada | Registered: 06 August 2003Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia