typo on the first one. Who would be a good gunsmith to restock and re-barrel a CZ 375

I know a couple, what you want to rebarrel too?
jeffe

want to rebarrel to 375 HH, probably with the 3 groove pac nor barrel, my factory barrel is disappointing in the accuraby department. Would like McMillan fiberglass stock.

My Factory CZ 375 was very poor in the accuracy department.... 3" at 50 meters A little bedding work, it is now less thant 1" at 100 yds with Varget.

I am working up some loads with Rel 15 to see where that leads me.

gi
let's arrange for you do drag that over to houston, with your original setup...

we'll crown it and bed it....

then, if it don't shoot, you can swap barrels and stock

jeffe

When I bought the gun, i sent it to RW Hart, they bedded polished bore, crowned muzzle & did trigger job. shot H4350, 760 & h414 with 30o swoft and bad accuracy

When I had my CZ rebarreled from 375 H&H to 500 Jeffrey, Harlan sent me back the original barrel. It shot pretty good, I think it's a McGowen barrel since I originally ordered my rifle from the CZ custom shop.



If you need it let me know and I'll ship it out ... It's just gathering dust.

Chuck

Saw an old post of mine come up, since then I had the rifle stocked by Brockman. When I got it back I put a 3 x 9 Zeiss on it, loaded RX 15 and shot 3 300 gr NF softs, 3 300 gr NF FPS and 3 3oo gr NF CPS into one ragged hole at 100 yards.

Everything changed with the stock.

Yup, assuming the barrel is good and most are, typically bedding is next. Though I could easily believe the spread in my group was completely due to my shooting degenerating with age except for the fact that the first shot was the lowest and last the highest. So probably only half the error was my shooting lol ...



Chuck

quote:

Originally posted by JBoutfishn:
My Factory CZ 375 was very poor in the accuracy department.... 3" at 50 meters A little bedding work, it is now less thant 1" at 100 yds with Varget.

I am working up some loads with Rel 15 to see where that leads me.

I used RE-15 on 350 Woodleighs in my Mod 70, but have had great success with IMR 4350 on 270 & 300 grainers. FWIW.