THE ACCURATERELOADING.COM MEDIUM BORE RIFLE FORUM


Moderators: Paul H
Go
New
Find
Notify
Tools
Reply
  
300 win mag trajectory question
 Login/Join
 
One of Us
posted
Hi everyone, I have a savage in 300 win mag shootin factory remington 150 gr ammo, i have it sighted in for 3in high at 100yds. My dilemma is i dont have any range close to my home to shoot long distance and im into long range (500+)yds varmint hunting and i was wondering if anyone could give me a rough estimate of where it might be hitting at 500 yds any input would be appreciated thanks alot
 
Posts: 163 | Location: York Pa | Registered: 21 January 2005Reply With Quote
One of Us
Picture of vapodog
posted Hide Post
roughly about 30 inches low.


///////////////////////////////////////////////////////////////////////////
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery."
Winston Churchill
 
Posts: 28849 | Location: western Nebraska | Registered: 27 May 2003Reply With Quote
One of Us
posted Hide Post
Colorado Sako 300wm 180gr Sierra Game Kings,72gr of IMR 4831,Rem9 1/2 mag primer, 600+ yds, Leupold 3x9x40 CPC reticle on 9 power held 2 ft over the front shoulder of a huge mule deer doe and broke her right front foreleg next one went into her chest & dropped her.
 
Posts: 1116 | Registered: 27 April 2006Reply With Quote
One of Us
Picture of woods
posted Hide Post
Hey bill

Not trying to cause trouble here, but that is about the poorest choice for a 300 win mag bullet I can imagine, no sectional density, low ballistic coefficient, more wind drift, probably not appropriate to the barrel twist rate of your gun, all of which translates into poor performance.


But if you insist on the 150 gr bullet then Vapo is right, about 30" with about that much wind drift in a 10 mph wind.


____________________________________
There are those who would misteach us that to stick in a rut is consistency - and a virtue, and that to climb out of the rut is inconsistency - and a vice.
- Mark Twain |

Chinese Proverb: When someone shares something of value with you and you benefit from it, you have a moral obligation to share it with others.

___________________________________
 
Posts: 2750 | Location: Houston, Tx | Registered: 17 January 2005Reply With Quote
One of Us
Picture of friarmeier
posted Hide Post
Play around with the Norma balistic program a bit. It's free and can be viewed on-line w/o downloading!

http://www.norma.cc/sida/eng/index.html

You'll need to "roll-over" the "ballistics" tab, and then, just under that bar, roll-over the "english" units (ie; not metric!).

It should be fun and will give you a good idea what to expect.

friar


Our liberties we prize, and our rights we will maintain.
 
Posts: 1222 | Location: A place once called heaven | Registered: 11 January 2005Reply With Quote
One of Us
Picture of friarmeier
posted Hide Post
quote:
Originally posted by scr83jp:
Colorado Sako 300wm 180gr Sierra Game Kings,72gr of IMR 4831,Rem9 1/2 mag primer, 600+ yds, Leupold 3x9x40 CPC reticle on 9 power held 2 ft over the front shoulder of a huge mule deer doe and broke her right front foreleg next one went into her chest & dropped her.


Uhhhh, and this matters...why?

friar


Our liberties we prize, and our rights we will maintain.
 
Posts: 1222 | Location: A place once called heaven | Registered: 11 January 2005Reply With Quote
One of Us
posted Hide Post
hey woods which should i use then 165 or 180 grn this is ,my first magnum and im still a little wet under the ears
 
Posts: 163 | Location: York Pa | Registered: 21 January 2005Reply With Quote
One of Us
posted Hide Post
IMO and experience with the .300 Winnie the 180 grain bullets are the only way to go. Find a good bullet, a load your rifle likes and practice with them and use them on any game you want to shoot in the US and elsewhere. One bullet one load. They work!
BJB
 
Posts: 514 | Location: now in Lower Slower Delaware | Registered: 21 June 2005Reply With Quote
One of Us
posted Hide Post
Hello bill23,

Below are some "come ups" that will give you a guideline to use for elevation. From your 100 yd zero, suggest the following for elevation and mind you these are accumulative:
1-200, 2 minutes, 2-300, 3 minutes, 3-400, 3 minutes, and from 4 -500, 3 minutes. This gives you a total "come ups" of 11 minutes or if your sight/scope, etc. is 1/4 moa per click, you are looking at 44 clicks up to put you on at 500 yards. W/ the 150 bullet, you are shooting a fairly "flat tragjectory" bullet and might be a bit on the high side. Should put you pretty much on if you are using the heavier bullets. Rule of thumb, from 100 to 700 yards, 3 minutes of angle elevation per 100 yards. Again, rule of thumb, but pretty well proven over the years to work well. After 700 yards, whole new world "out there..." Hope it works for you.
 
Posts: 577 | Registered: 19 February 2006Reply With Quote
One of Us
Picture of woods
posted Hide Post
Hey bill

I agree with BJB, the 180 gr bullet is a minimum for factory loaded ammo. If you were reloading then the 168 Barnes Triple Shock would be a good load. With factory ammo the 180 gr in a good bullet such as Nosler Partition, Nosler Accubond, Trophy Bonded Bear Claw, Scirocco or Barnes Triple Shocks loaded in Federal Premium line would all be good. If budget is a problem then get the Remington Core Lokt, but make it the 180. The performance in the field will be much better.

However, I just noticed that you were going to be shooting varmints with it. The 300 win mag is too much gun for that but better than not hunting varmints at all. I would still recommend shooting the 180 gr bullet just for the practice. Come in handy during the deer season.


____________________________________
There are those who would misteach us that to stick in a rut is consistency - and a virtue, and that to climb out of the rut is inconsistency - and a vice.
- Mark Twain |

Chinese Proverb: When someone shares something of value with you and you benefit from it, you have a moral obligation to share it with others.

___________________________________
 
Posts: 2750 | Location: Houston, Tx | Registered: 17 January 2005Reply With Quote
One of Us
Picture of MarkH
posted Hide Post
Hi Bill

Try this link out.

http://www.eskimo.com/~jbm/ballistics/traj/traj.html

With Remington core-lokt it says 31.6"

Regards

Mark


Hunting is getting as close as you can, shooting is getting as far away as possible.
 
Posts: 537 | Location: Worcestershire, England | Registered: 22 March 2005Reply With Quote
One of Us
Picture of cobra
posted Hide Post
quote:
Originally posted by BJB:
IMO and experience with the .300 Winnie the 180 grain bullets are the only way to go. Find a good bullet, a load your rifle likes and practice with them and use them on any game you want to shoot in the US and elsewhere. One bullet one load. They work!
BJB


I would have to agree.


 
Posts: 8827 | Location: CANADA | Registered: 25 August 2004Reply With Quote
One of Us
posted Hide Post
I agree with BJB but would select a 200gr bullet. If you're wanting to shoot `150gr bullets, a 30-06 or a .308 would give you all the real world speed you would need.
 
Posts: 367 | Location: WV | Registered: 06 October 2005Reply With Quote
one of us
Picture of solvi
posted Hide Post
After 3 years of trying different bullets and loads I have found the right food for my 300WM Sako 75.

76, 3 g Vihtavuori N165
Lapua shells
180g Oryx.

Works every time.


Skype username
solvijoh
 
Posts: 497 | Location: Iceland | Registered: 27 October 2002Reply With Quote
one of us
posted Hide Post
My .300 Winnie likes 180 grain Nosler BT's best followed by 165 Nosler BT's. However I am getting 1-1.5 inch groups at 100 yards with 125 grain BT's
Just started playing with them for ground hog shooting under 300 yards. Not much of a varmint hunter but figured the practice with my deer rifle would be good.


Don Nelson
Sw. PA.
 
Posts: 622 | Location: PA. U.S.A. | Registered: 12 May 2002Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia