Go | New | Find | Notify | Tools | Reply |
one of us |
Anyone else use these? I use them to practice in the basement. Great fun. - Dan | ||
|
Administrator |
Dan, We used to use them a lot before we built our undrground range. If you cannot find any, you can use normal brass cases and wax for bullets. It helps if you drill out the flash hole make it large - you have to mark the cases somehow so as not to use them for normal loads again, as this will certainly increase the pressure. I just paint them red with a marker pen. We melt wax in a pan to the required thickness, and just use the case mouth to cut a plug. | |||
|
one of us |
Thanks for the idea Saeed. I'll have to try that too. - Dan | |||
|
one of us |
Yes, I fired one (in 44 cal) into a pine 2 x 4 just to see what would happen. It went in about 1/4", far enough to make me not want to be shot with one. - Dan | |||
|
Moderator |
I used to shoot them alot as a kid out of my dads S&W airlite 38 special. I still have them, and fired a few out of my wifes Taurus 357. Now that I have an air pistol, I prefer to shoot it, it is more accurate, quieter, and pellets and primers cost the same. | |||
|
one of us |
I tried to kill a rat with one once out of a .45 ACP. It didn't seem to hurt the rat much, but traumatised it enough that it just sat there and shivered while I loaded a real bullet in the cylinder with which to terminate him. | |||
|
one of us |
This sounds like fun, can you also load them for rifles? and if you can will a primer give enough pressure to drive the wax out of the barell and to the target? Then, what would be the max effective range? And finally, do you need to clean your bore after all the fun. Thanks, Charlie | |||
|
Powered by Social Strata |
Please Wait. Your request is being processed... |
Visit our on-line store for AR Memorabilia