THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
7-30 waters
 Login/Join
 
new member
posted
Looking for 7-30 waters dies, looking for forming and trim dies to make 7-30 from 30-30
 
Posts: 2 | Location: SC | Registered: 29 October 2003Reply With Quote
one of us
posted Hide Post
shouldn't need form and trim dies. I just run new or even once fired 30-30's thru my 7-30 die a little at a time just til it will fit in my TC. This gives the brass a secondary shoulder to headspace on until you fireform it. Once its fireformed the length won't be a problem for at least a couple firings and possibly more. Fireform loads actually shoot quite good...........
 
Posts: 901 | Location: Denver, CO USA | Registered: 01 February 2001Reply With Quote
one of us
Picture of Hobie
posted Hide Post
A set of dies will suffice for forming. Lube, run .30-30 case into sizing die. Load as you would any other 7-30 (some modification to load might be necessary if you're using a high load density powder). Shoot. You have your cases. Works great. If you shoot cast, you can practice while forming cases.
 
Posts: 2324 | Location: Staunton, VA | Registered: 05 September 2002Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia