THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
Case Capacity of 416 Rem
 Login/Join
 
one of us
posted
I need to compare some 416 Rem loads. Can someone tell me what the case capacity of a 416Rem in weight of water? Thanks. Ku-dude
 
Posts: 959 | Registered: 27 February 2001Reply With Quote
<Don Martin29>
posted
My Calculoader says it's 107.4 but this is the same program that says the 30/06 Sprg. holds more than the same cartridge improved!
 
Reply With Quote
one of us
Picture of ricciardelli
posted Hide Post
First you zero balance your scale;
Second you fill your case with water;
Third you dump the water onto your scale
And finally, you read the scale!
 
Posts: 3282 | Location: Saint Marie, Montana | Registered: 22 May 2002Reply With Quote
<Don Martin29>
posted
quote:
Originally posted by ricciardelli:
First you zero balance your scale;
Second you fill your case with water;
Third you dump the water onto your scale
And finally, you read the scale!

I do it by weighing a case that has a dead primer in it, filling the case with water and weighing it again.

I am concerned that surface tension and water soaking into a dirty case would change the actual water capacity of a case.
 
Reply With Quote
<500 AHR>
posted
Case capacity of the 416 Remington is approximately 105 grains of water.

This will vary a little from manufacturer to manufacturer and lot to lot.
 
Reply With Quote
one of us
posted Hide Post
Steve and Don,
And that is exactly what I'd do if I had a 416Rem case! Thanks. I am trying to work from 416 data back to another case.

Good to see your page back up Steve.

Thank you, Todd. I think I can work this out now. Ku-dude

[ 09-04-2002, 20:52: Message edited by: Ku-dude ]
 
Posts: 959 | Registered: 27 February 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia