THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
8X57 (.323) load data needed
 Login/Join
 
One of Us
posted
Hey guys, been a member for a few weeks, but this is my first posting. I am working up some new loads for my Yugo 8x57 and I was hoping someone with quickload can run some numbers for me...here are the stats:

Powder = H414
Bullet = Nosler Ballistic Tip 180grn (.323)
Brass = Rem. 8x57 (.323)
Primer = CCI 200
Collective Overall Length = 3.20"
Barrel Length = 23.5"

I know H414 is a little on the slow side for the 8x57 (I usually load H4895), but I am playing around with it anyway. Looking for a good full case, slightly compressed is OK too. I need some safe starting and max charges for this combo. Thinking 48 start to 53 Max grains, but want to make sure I'm in the safe limts before I pull the trigger. Thanks!
BTW- Headspace is fine in the gun, I am looking for euro spec CUP charges, not the anemic american stuff. Thanks again!!
Jeremy


"Trust in the Lord with all your heart. In all your ways acknowledge Him, and He will direct your paths."
 
Posts: 411 | Location: Little Rock, AR | Registered: 10 September 2007Reply With Quote
one of us
Picture of TCLouis
posted Hide Post
Hodgdon's manual lists
170 SPR SP
H414 49.0 2446 53.00 2586
Drop back for the extra bullet weight and creep up on max looking for signs as a good reloader ALWAYS does.
Should be enough to get one started.



Don't limit your challenges . . .
Challenge your limits


 
Posts: 4270 | Location: TN USA | Registered: 17 March 2002Reply With Quote
One of Us
posted Hide Post
Louis,
Thanks. I always work up slow from the min charge...just wanted to make sure that my start of 48 grains was OK, and wondering how far I might be able to (hopefully) go with it. Sounds like 48 to 53 is about right...thanks!
Jeremy


"Trust in the Lord with all your heart. In all your ways acknowledge Him, and He will direct your paths."
 
Posts: 411 | Location: Little Rock, AR | Registered: 10 September 2007Reply With Quote
One of Us
posted Hide Post
Nosler lists loads for three different powders for that bullet/cartridge, but not H414:

Nosler 180 BT 8x57 data

Andy
 
Posts: 315 | Location: Arlington TX | Registered: 21 October 2005Reply With Quote
One of Us
posted Hide Post
quote:
Originally posted by jdunlapmo:


Powder = H414
Bullet = Nosler Ballistic Tip 180grn (.323)
Brass = Rem. 8x57 (.323)
Collective Overall Length = 3.20"
Barrel Length = 23.5"



Quickload says:

58.2 gr gives 104.8% case fill, 65,440 psi, 2862 fps
48 gr gives 86.4% case fill, 35,819 psi, 2339 fps


I find that if Quickload says 72,000 psi for a Mauser case head [8mm, .308, etc], I can get away with it at the range, and have 5 shots of no sticky bolt or loose primer pockets. But just barely. I like to hunt with ammo derated to 65,000 psi, to allow for the ammo or chamber getting dirty.
 
Posts: 9043 | Location: on the rock | Registered: 16 July 2005Reply With Quote
One of Us
posted Hide Post
tnekkcc,
Thanks for the help. I pushed it to 54 grains yesterday with no pressure signs, but that was beyond the books, so I was getting nervous. Looks like if I'm careful, I can keep easing up a couple more grains in small increments. Many thanks!
Jeremy


"Trust in the Lord with all your heart. In all your ways acknowledge Him, and He will direct your paths."
 
Posts: 411 | Location: Little Rock, AR | Registered: 10 September 2007Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia