The finished producted seems ok.

Just new and poranoid!

As always thanks.

If the rounds are shooting acceptably well for you and the brass isn't being harmed, then I wouldn't worry about it. Then again, I'd probably send the thing back to Lee ASAP and ask them to make good on their boasts of "quality."

Save up your nickels and dimes and buy a Forster Co-Ax press, and you'll never have to worry about penny ante stuff like this again.

RSY

quote:

---

Originally posted by stans:
The only Lee product that seems to get nearly universal praise is the factory crimp die.

---

I would agree with this, but would also add the Lee hand primer to the list. Most folks that have these like them. Though, I use a Hornady unit, myself.

RSY

If not, move the opening of the shellholder to the side the case is tipping tward as it enters the die to let the casehead slide over as it moves up.

I had similer problems with my Lyman T-Mag press, that and the cheesy loose head and screw on the back.

Those days ended yesterday when a new Dillon RL550B was bolted to the bench. It was a toss up between it and the Co-Ax. But the Co-Ax arm wouldn't clear the competition dies larger than .308win. and the decision was to go with the one I could leave my dies set up in. I haven't checked run out yet but it should be minimal.

[This message has been edited by Big50 (edited 11-17-2001).]

I used an RCBS "Rock Chucker" for years, many, many rounds. Finally got tired of that and bought a Lee "Load Master" because money was tight. I'm real happy with it. I've only used it for pistol ammo to date, but plan on trying .30 Carbine and .223 as soon as I get the shell holders.

I'm also fond of their dies. I've used RCBS and Hornady dies, and as long as I do my job, the "Load Master" and Lee's dies do theirs. I did have a learning curve at first, and I had to "tweak" some of the adjustments besides polishing some of the bearing surfaces a little. I've had it almost four years now and it works fine.

I'd check the alignment of the shell holder and you may try the o-ring that Zeke suggested. The Load Master comes with one between the shell plate and the retaining nut. It would also be a good idea to run the shell up into the die and then tighten the locking ring.

Good luck.

------------------
Surely we must all hang together, for separately we will all surely hang.

Thanks Everyone

I think I will get a factory crimp die and the trimmer for every caliber I reload. And I use their Autoprime handheld, too.

Good shooting H

------------------

And let me add Lee's book on reloading - a good reading

[This message has been edited by waitaminit (edited 11-19-2001).]