As of today, here are the initials and zip codes of the folks whose checks I have received for the little Lee soup can 6-cavity molds:

EB -64503
CC -74429
LB -37179
KC -97754
RT -97754
GT -57317
SH -30523
RT -92373
EG -22032
RA -15701
GL -83201
RA -76087
BM -13642
CR -43724
JA -97223
RD -L9S 2B6
DF -48160
LG -63146
SD -28457

To clear up any confusion, I think it was felix who came up with this method (initials & zip). Imitation is the sincerest form of flattery, don'cha know! <GGG>

Between the "6 hole soup can" mould and the Felix lube I'll be waiting like a dog for the mailman.

AKA elbStJoeMO

Just got another status update from Lee on our little soup can mold. They have started production! Said I can expect to have the molds in-hand next week.

Y'all better get busy scrounging WWs. With the BD45 and this one, we're gonna run the tire shops out of weights!

Yippee Do Dah

I had best go looking for some wheel weights, bet I don't have more than 4-500 pounds of ingots and that ain't gonna go far with a "Six-Holer".
I can't wait to see how max sized (as cast or so) does in my 7.7X58.
LouisB

Anybody out there got some good suggestions for lightening the trigger pull on that trusty old Japanese Type 99? No, not buying one of the new whiz bang triggers, I'm too . . . TOO cheap to do that!

MOPC= Minute of clay pigeon chip

[ 11-05-2003, 06:00: Message edited by: TCLouis ]

I just picked up a Rossi combo youth gun in 308/ 20ga for the 5yo Son. I'm thinkin this bollit will be just the ticket for him. He likes shooting my 06 with 165's, but I think he'll do better if I cut the stock off to fit him on the rossi. I'll drill two holes for future alignment pins, then cut it off and add back in sections as he grows.

LAR45,
I hear you, I just picked up a 16 inch stainless carbine barrel for my contender and fitted it with a 1.5x4.5 scope with a bantam stock for my daughter to shoot...it's a 30-30 so that she can grow with it. I'm also planning on starting her out with cast soupcan loads and them move her up to my 311041 full power loads as she progresses.

can't wait for the mould to arrive. Special thanks to Grumble for making this all happen. Maybe if this works out, we can come up with a group buy of Bator's 200 grain 358 bullet in a 6 cavity...

regards,
Graycg

Grumble,
any of these molds left un-spoken for?
LostCajun

Lar45

This bullet sized to 0.309" in front of 9.1 gr. of Red Dot will hold minute of clay pigeon chip at 100 yards in my 7.7X58. These were cast in my two holer. Gonna try the next ones thru a 0.310 die and see if it will tighten up a tad and run it thru various 30 cal guns from the carbine up!

LouisB

I think there were about 9 people who spoke up for the Bator 200 6 cav at Cast Boolits. I'd be up for one if there is enough interest.

I'd grab one of those 358-200 Bator's in a 6 banger, in a hot minute. I really like the way my 358-250-Bator casts, I just don't have a "launching" platform YET.
krag35