Looking for suggestions for some heavy cast bullets for a single shot pistol chambering. e-mail at drminak@hotmail.com Thanks!

I have a Lyman 412263 RN 288 gr bullet. I haven't cast or shot any yet but I do have a RBH, T/C, and a Marlin 41 mag to try it in.

HHI, Leadhead makes a 265 gr. round flat nose GC bullet. It is reputed to shoot well in the 14" twist of a FA revolver. Doesn't shoot very well in the 18" twist of my Dan Wesson. RCBS makes a 300 grain CAS bullet meant for the .40-65 that drops at about .411.

NEI has one that makes a .410, mine weigh 437-439.

I have an LBT lfn mould which throws a 315gr bullet. In order to get it to work in my Dan Wesson, I had to trim the brass a little short. Can't remember with 100 percent certainity, but 1.23" seems to stick in my mind. I really haven't had any chance to play with it. Seems like I was haveing so-so accuracy out to about 50 yards. I have heard that at longer distances with slow twist barrels, the stablization goes to pot. If you are interesed, I could send some to you if you are willing to pickup the postage.

Below is a link to the IHMSA chat, navigate to the bigbore loads and there is a thread on heavy .41 bullets. The loads are mainly for Freedom arms revolvers.

Main IHMSA Chat
http://www.aimoo.com/forum/freeboard.cfm?id=388847

.41 loads
http://www.aimoo.com/forum/postview.cfm?id=388847&CategoryID=90456&startcat=1&Thr eadID=760329

[ 09-25-2003, 15:27: Message edited by: 7br ]