Anyone got a picture of these bases installed on Ruger No. 1 they could share?

Moulds Ruger #1 scope bases

Thanks, Wayne E.

tnekkcc,
I would sure like to see those on a #1.

EDG

quote:

Originally posted by tnekkcc:
I could get you pictures of these

Would love to see 'em.

Wayne

Left side:





Right side:

tnekkcc,

Thanks for taking the time and effort to post those photos.

Wayne

Yea that is a better setup for putting the rear ring back over the receiver.

Great info.
The sad thing is that they are out of stock at Brownells, otherwise I would have ordered one set right away...

Old topic, I know, but here is a picure of a gun I recently bought with this set-up. It is not as high as I thought it might be, so with low rings it should equal, or maybe be even be lower than, the standard set-up with low Ruger rings.

L Clark, thanks for the pic,

and welcome to the forum.

Wayne E.

I made this mount from a generation I Tapco AR15 riser. It has 6 holes through it. I had some 8-36 screws, and I shortened them. The radius in the rear is constant, but in the front the only way to match the taper is to glass the mount to the barrel.




The trick for me to hanging on to Weaver mounts was modifying some V-blocks. Here they are in a different application, but think upside down with an AR getting a new radius milled on the bottom.