One of Us
| Very close. I had to file mine a bit. This is not an intimidating install.
Matt |
| | | Posts: 374 | Location: Anchorage AK | Registered: 26 April 2006 | 
IP
|
|
One of Us
| I installed the Trop safety on 2 of the #1's I have. An easy installation as Matt stated. May require a little fitting. A very nice improvement over the factory safety. |
| | | Posts: 2173 | Location: NORTHWEST NEW MEXICO, USA | Registered: 05 March 2008 |
IP
|
|
one of us
| Thanks! |
| | | Posts: 819 | Location: Missouri | Registered: 24 May 2002 |
IP
|
|
one of us
| OK, another question... is it gloss or matte finish? |
| | | Posts: 819 | Location: Missouri | Registered: 24 May 2002 |
IP
|
|
One of Us
| I don't recall, but I think gloss. |
| | | Posts: 2173 | Location: NORTHWEST NEW MEXICO, USA | Registered: 05 March 2008 |
IP
|
|
one of us
| I got an email from them; it is gloss. |
| | | Posts: 819 | Location: Missouri | Registered: 24 May 2002 |
IP
|
|
One of Us
| Didn't have to file at all but did a lot of jiggling to get it in. Of coarse I'm ham fingered. Neat installation and doesn't look bad either.
SCI Life Member
NRA Patron Life Member
DRSS
|
| | | Posts: 2786 | Location: Green Valley,Az | Registered: 04 January 2005 |
IP
|
|
One of Us
| I didn't have the third hand I needed so off to the gunsmith. Cost me $25 but it saved my blood pressure. If you are not good with your hands, good luck! |
| | | Posts: 3073 | Location: Pittsburgh, PA | Registered: 11 November 2004 |
IP
|
|
