Just wondering if anyone has used a belt sander to grind a recoil pad down to size? I have an ugly old ADL that will probably become my guinea pig for first gunsmithing projects: Recoil pad, stock refinishing, lug lapping, glass bedding...if a rookie can find all the potential pitfalls the first time, it's me...
Thanks, Mike.

I'll work fairly well if you put the sander in a vise and use it that way... Wouldn't try holding one by hand.

Hello:
I did this a while ago, using one of those little bench sanders. It worked well, but I wrapped the Butt area with 1.5 in. Masking tape to protect it in case I erred.
Grizz

sure, mount it on a bench, or vise, like said...

you'll need to get a bsquare recoil pad tool... and it'll make it ALL very much easier... i can do it by eye... and it always shows
jeffe

I used a stationary belt sander until I got a large 12" disc sander. If you are trying to sand to a finish surface let me give you a little tip. Put one thichness of masking tape just at the juncture. Sand until the pad is very close but without touching the tape. Loosen the screws and push the pad to one side , tighten the screws and then sand that side again very carefully. Then do the same process to the other side and you will be amazed how close you can get it.

I am presently using a bench mounted belt grinder just because I havn't gotten around to setting up the disc grinder (these things take time and 5 years isn't enough!). The disc grinder is better but the belt grinder's OK. Regards, Bill.