OK, I was re-assembling the bolt on my RSM when the finish nail used to hold the bolt in the correct position slipped out. How can I get the bolt back together after screwing the firing pin assembly in? I need to get it further into the correct "cocked" notch.

I did a search without any help. I should know how to do this but I am drawing a blank. I need to get to the range this afternoon, so any help will be greatly appreciated.

Hook the cocking sear over the edge of a toolbox to pull it back while turning the bolt.

That's not working for me, so I called your boss and he talked me through it. All is well, and thanks to Wayne at OREGONGUNSMITHING LLC.