The Accurate Reloading Forums
Barrel band swivel

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/882104371

07 January 2005, 08:19
dian1
Barrel band swivel
Interested in methods of attaching a barrel band before bluing.
I had considered silver soldering (force 44) but the fellow who will be doing the bluing indicates that he would not be comfortable with anything other than brazed/silver brazed. Because of the heat required I am unwilling to use that option.
Also considering drilling the band and barrel for a cross pin.
Any thoughts or tried-and-true methods would be appreciated.
07 January 2005, 09:26
Customstox
Acraglass (epoxy) works well.


Chic Worthing
"Life is Too Short To Hunt With An Ugly Gun"
http://webpages.charter.net/cworthing/
07 January 2005, 19:20
Scrollcutter
Use your solder and send the rifle to a gunsmith that does a quality rust blue. No worries then.


Roger Kehr
Kehr Engraving Company
(360)456-0831
07 January 2005, 19:59
butchloc
there are low temp silver solders which will go through the caustic blue OK. by all means don't cross pin the barrel
07 January 2005, 23:17
Jim Kobe
Chic, I think the Acraglass would come loose with the heat from the blueing. I have used force 44 solder many many times and it will not be affected by the blueing salts or heat. Just make sure you flux it well and get a good flow. I agree, silver solder is way too much heat. I haven't used it on a gun in years, maybe a Reimington 700 bolt handle and some carbide inserts for a boring bar.


Jim Kobe
10841 Oxborough Ave So
Bloomington MN 55437
952.884.6031
Professional member American Custom Gunmakers Guild