THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Ruger Mark II bedding question
 Login/Join
 
One of Us
posted
I do not have any experience in bedding a Ruger so I hired this job out. It is a Ruger LH ss Mark II that now carries a Lilja barrel in 338 WM and is pillar bedded in a McMillan stock. After getting the stock back I had to remove some bedding and do some cleanup work on the floorplate to get it to close and release easily. That issue is hopefully resolved. But when I put the barreled action into the stock I noticed the tang was bedded in tight with zero clearance behind it.
Should I remove some material to allow some clearance?


My biggest fear is when I die my wife will sell my guns for what I told her they cost.
 
Posts: 6654 | Location: Wasilla, Alaska | Registered: 22 February 2005Reply With Quote
One of Us
posted Hide Post
The stock isn't going to be affected by environmental conditions, and I doubt the action will expand and contract enough to cause any problems, so I wouldn't worry about it.
 
Posts: 1374 | Registered: 06 November 2005Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia