Hey guys, can't find the rust cabinet plans that came with the gun goddess solution, anybody got a copy or another desing they can post? I have a single bulb light fixture I took off the ceiling when I installed my flourescents. Gotta go get some plywood this week anyways and break out the table saw, might as well do this at the same time.

Red

Dago,

Send me an e-mail with you snail mail address. I will send you the plans that I made based on the John Bivins articles in Rifle magazine, the Bivins articles and the plans from the Gun Godess package.

I used furniture grade birch plywood, but got spanked for not using exterior grade. If they will rip the plywood for you at the lumer yard, have them make four pieces that are 15" or 16" wide, and as long as you want. will be doing some muzzle loaders and 50 caliber barrels over the years so my pieces are 72" long. If you will just be doing sporter rifles you can get away with 60" long (easier to shorten later than lengthen, plan on two sheets of plywood, etc. etc.).

Anyway, give a shout and I'll get the infor out to you.

LD

PS One change I am making is to put some pieces of Plexiglass into the front door so I can see how the rusting is coming along without opening the door. I got that idea from one of Jack Belk's on line phot albums from the time he rust blued a chopped S&W revolver.

Good ruck!

thanks, snail mail sent. the plexiglass is a good idea. I'll go 6', since standing up won't make much nevermind height wise.

Red