One of Us
| |
| | | Posts: 189 | Location: Western Kentucky | Registered: 02 November 2007 | 
IP
|
|
One of Us
| yes that is almost identical to what I am looking for but without the holes for the screw since it will be silver soldered to the barrel thank you very much
"That's not a knife..THIS is a KNIFE" !
|
| | | Posts: 6572 | Location: NEW ORLEANS / CAJUN COUNTRY!!! | Registered: 05 September 2005 |
IP
|
|
One of Us
| OK, I know what you are looking for. Perhaps someone will turn up a source, if not you might start with Gentry part and cut off a section of band....or just make the entire part from scratch. |
| | | Posts: 189 | Location: Western Kentucky | Registered: 02 November 2007 |
IP
|
|
One of Us
| Thanks Guys! My smith said he can make it now...; )
"That's not a knife..THIS is a KNIFE" !
|
| | | Posts: 6572 | Location: NEW ORLEANS / CAJUN COUNTRY!!! | Registered: 05 September 2005 |
IP
|
|
One of Us
| |
| | | Posts: 2694 | Location: South Otago New Zealand. | Registered: 08 February 2009 |
IP
|
|
One of Us
| Yes!!
"That's not a knife..THIS is a KNIFE" !
|
| | | Posts: 6572 | Location: NEW ORLEANS / CAJUN COUNTRY!!! | Registered: 05 September 2005 |
IP
|
|
