THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Accurizing question on Rem700
 Login/Join
 
one of us
Picture of Blacktailer
posted
I have a Rem700 in 223 that shoots 1.25-1.5 MOA. I replaced the original barrel because it was 1 in 14 with a Douglas 1 in 9. While this was being done, the smith lapped the lugs and cleaned up the action. I have swapped out the scope with no improvement. It has a tupperware stock that I have bedded with some improvement but I would still expect this rifle to give sub MOA. The Remington trigger is set to about 2 1/2 pounds. My other hunting rifles (30-06, 300 RUM, 375 H&H all give sub MOA groups with lesser magnification scopes so it isn't my eyes. I have tried several types and weights of bullets and powders. Do you think the stock is the problem? I've been thinking about a laminated stock with pillar bedding or one of the composites with a full length aluminum bed. Any ideas what to check next?


Have gun- Will travel
The value of a trophy is computed directly in terms of personal investment in its acquisition. Robert Ruark
 
Posts: 3831 | Location: Cave Creek, AZ | Registered: 09 August 2001Reply With Quote
one of us
Picture of Toomany Tools
posted Hide Post
I recently worked a new Rem 700 in .223 for the same problem. I glass-bedded the action into the aluminum bedding block and recrowned the barrel, resulting in consistent sub-MOA groups. The injection-molded Remington stocks are garbage.


John Farner

If you haven't, please join the NRA!
 
Posts: 2946 | Location: Corrales, NM, USA | Registered: 07 February 2001Reply With Quote
one of us
Picture of Doc
posted Hide Post
I suggest a new stock and a good bedding job.


Ted Kennedy's car has killed more people than my guns
 
Posts: 7906 | Registered: 05 July 2004Reply With Quote
One of Us
Picture of Tapper2
posted Hide Post
You have already eliminated the most common accuracy problem, the scope, so I would look at the next ones in-line. As toomany tools said, the Remington plastic stock is junk and not worth trying to fix. Pillar bedding is normally a big improvement. If the crown is damaged recrowning can be a huge improvement. Depending on how much you want to do yourself and how much you want to spend. A laminate, straight wood or composite stock that is properly bedded will most likely solve your problem. If that doesn't work, recrown. If that doesn't work....Trade it off......Tom


SCI lifer
NRA Patron
DRSS
DSC
 
Posts: 654 | Location: Denver, Iowa | Registered: 10 June 2009Reply With Quote
one of us
Picture of Blacktailer
posted Hide Post
Thanks guys, I was kind of thinking the stock might be the problem.


Have gun- Will travel
The value of a trophy is computed directly in terms of personal investment in its acquisition. Robert Ruark
 
Posts: 3831 | Location: Cave Creek, AZ | Registered: 09 August 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia