The Accurate Reloading Forums
Best paint finish for a ratty action?
Best paint finish for a ratty action?
I have a somewhat pitted Mauser Oberndorf action I finally figured out a project for, I'm going to fill in the pits with a filler then paint it with a spray and bake, just figuring out what appearance to use- gloss, satin, or flat.
Gloss is pretty much out as it will highlight the imperfections IMHO, so I'm thinking of using a satin black but I was also thinking a flat grey might have a nice even look. Whatever color I intend to do the barrel the same as well.
Anyway, interested in others opinions.
Thanks,
Mark
for every hour in front of the computer you should have 3 hours outside
05 March 2021, 10:11
georgeldIF you like bright flat black.
Try Aluma Kote, not any heat set needed.
Makes a nice finish on nasty looking metals.
Make sure you shake the can good and often. Don't
let it sit on the shelf for months as it seems to
set up. then it's a bitch to get shook up again.
George
"Gun Control is NOT about Guns'
"It's about Control!!"
Join the NRA today!"
LM: NRA, DAV,
George L. Dwight
05 March 2021, 11:30
muzzaWhat about Cerakote?
________________________
Old enough to know better
05 March 2021, 18:34
jeffeossoflat black engine paint - get the metal warm to hot first ..
Brownells AlumaHyde 2, although the engine paint idea might be better; it is the same stuff that the name brand rifle coaters charge $250 for.
Best to sand blast the metal first but not necessary. Degrease with xylene no matter what paint you use. And make no mistake, all these coatings are, paint of some ilk.
05 March 2021, 21:09
Gringo CazadorI've done the engine paint more than once on old beater rifles.
I hung a old Browning BBR barreled action in a Mesquite tree many years ago in my yard in the Hot as hell South Texas sun for a few hrs. I bet it was 105 degrees that day in the shade. I hit it with Hi Temp Eng paint, let it dry in the sun and looked like it had been sent out and coated. That was 20 yrs ago it still looks good.
I still perfer a good blue job!!!
Billy,
High in the shoulder
(we band of bubbas)
Mark,
I had a similar rifle and used Krylon flat black. Since I didn't use filler first, I used heavy coats. Covered the pits. It's not pretty, but the flat black hides the poor surface finish pretty well.
That said, I think grey would look really neat if the filler levels stuff out pretty well.
06 March 2021, 04:41
Brian CanadaI heat the part first to about 150 then spray several thin coats of Krylon. Thin coats keep the "flat" appearance. Thick coat looks too shiny sometimes. Read instructions. Good luck.
IHMSA BC Provincial Champion and Perfect 40 Score, Unlimited Category, AAA Class.
06 March 2021, 04:51
HipshootI've used Rustolium Semi-gloss black which worked well and held up well. The only problem I have had is the paint disolves at the underside of the muzzle due to solvent when cleaning the bore.
Hip
Hey Hipshoot. Try putting 5 or 6 coats of polyurathane over the rustolium. It seems to help to keep the cleaning solvents off.
06 March 2021, 19:06
HipshootThanx! Will ry it.
Hip