THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Metal checkering question
 Login/Join
 
Rolland
One of Us
posted
I am in need of checkering a bolt release on a Mauser what would be the correct, or best lines per inch for something that small


Never rode a bull, but have shot some.

NRA life member
NRA LEO firearms instructor (retired)
NRA Golden Eagles member
 
Posts: 1514 | Location: Camp Verde, AZ | Registered: 13 December 2005Reply With Quote
Scrollcutter
one of us
Picture of Scrollcutter
posted Hide Post
I prefer fairly fine checkering. Something in the area of 50 lpi.


Roger Kehr
Kehr Engraving Company
(360)456-0831
 
Posts: 1634 | Location: Washington State | Registered: 29 December 2002Reply With Quote
zimbabwe
One of Us
Picture of zimbabwe
posted Hide Post
I prefer a #1 (40lines). To me a #2 (50lines) looks best but doesn't FEEL as good. Also depends on whether it's angled,rounded,or flat. If it's rounded I use 50 lines.


SCI Life Member
NRA Patron Life Member
DRSS
 
Posts: 2786 | Location: Green Valley,Az | Registered: 04 January 2005Reply With Quote
Rolland
One of Us
posted Hide Post
Who could I send this bolt release to for checkering. I don't have the need to purchase a file for just this job. You can PM if you wish. or email at greenrivergw@msn.com


Never rode a bull, but have shot some.

NRA life member
NRA LEO firearms instructor (retired)
NRA Golden Eagles member
 
Posts: 1514 | Location: Camp Verde, AZ | Registered: 13 December 2005Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia