Jordan

I then true them up with a barrel facer (Brownell's) If you don't want to spend for a facer, just file them square.

The hacksaw is not really a bad route (and safer), just use the factory end against the action or lug and put your "custom" end toward the bottom metal. If you bed the bottom metal at all the squeeze-out will take care of any slight out-of-squareness.

It's not worth your time or money to get someone else to do it.

[This message has been edited by steve y (edited 02-20-2002).]

quote:

---

Originally posted by Jordan:
Is anyone interested in getting paid to make a set of bedding pillars for a Small Sako? I could order from Brownell's and then hacksaw to the correct length, but I don't want a butcher job. Anyone want to make me an offer? I can e-mail the specs. Sorry if I am violating a board rule by engaging in commercial activity here.

if you have a drillpress or can borrow someones email me.

Jordan

---

------------------
Death Before Dishonor

The whole purpose of this board is to get help from our friends who visit it.

I hope you get what you want.

------------------
saeed@ emirates.net.ae

www.accuratereloading.com

Celt

[This message has been edited by Celt (edited 02-20-2002).]

Get some suitable tubing from the hardware store. They make some all thread kind of stuff for making electric lamps. Cut it a hair longer than you want. Chuck one of the pieces in an electric drill. Secure the drill in a vice. Turn it on. You just made an improvised lathe. File the end of the piece until it is square and even. Polish the end with sandpaper. It will look fine.

[This message has been edited by scot (edited 02-20-2002).]

------------------
NRA Life member

Sincerely,

Jordan