The Accurate Reloading Forums
Can injection molded stocks be used for bedding?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/563105341

17 July 2004, 00:48
SAKO75
Can injection molded stocks be used for bedding?
i was at a gunshop the other day and heard the guy behind the counter talking about glassbedding a gun with a factory injection molded plastic stock. is this common? is it practical?
17 July 2004, 01:07
p dog shooter
Yes I must have done a dozen by now. I use Brownells glass for this. I put in mechcanical locks roughing the surface, drilling dead end holes, cutting slots with dremil tool in the area I want to glass.

Works very well I haven't had one come loose yet.
17 July 2004, 01:20
Tomjac
Quote:

Yes I must have done a dozen by now. I use Brownells glass for this. I put in mechcanical locks roughing the surface, drilling dead end holes, cutting slots with dremil tool in the area I want to glass.

Works very well I haven't had one come loose yet.


Will the same method work on a Hogue stock as well??
17 July 2004, 06:42
dan belisle
It should Tom. I haven't done a Hogue stock this way yet (I don't own one), but I've done it to factory injection molded stocks from Ruger, Remington, Winchester and Savage, as well as Ramline, Bell and Carlson and Six Enterprises aftermarket stocks, and it's worked on all of them so far. - Dan
17 July 2004, 10:28
p dog shooter
I haven't done a Hogue But every thing else it should work just fine