The Accurate Reloading Forums
Machinists : Can this be done?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/56010684

24 April 2003, 18:55
Pyrotek
Machinists : Can this be done?
Had an idea of turning a 3-in-1 machine into a makeshift surface grinder. By mounting the grinding wheel on the mill spindle(might need extension to reach down), with work piece clamped on a vertical mounting jig on the lathe carriage, X-axis movement locked, work done by moving Y-axis and lowering(micro-feed) the mill shaft to cover all surface that need to be worked. Mill rotation is reversed so the grinding dust and mist is not thrown to the operator's side.

Any suggestions?
25 April 2003, 00:11
222blr
usually grinding operations are done with high rpms(3000)...you would need to dress the wheel, with a diamond after it was mounted....most grinding machines I have seen have good guards to protect the operator from an expoding wheel.....if something catches or the wheel busts...you will be open to the debris. what dia wheel are you thinking about?.....bob
25 April 2003, 01:47
Jay, Idaho
If you reverse the spindle direction be sure to use a L.H. thread to hold the wheel in place. Most grinding machines move the part, relative to the wheel in "feet per second" instead of "inches per minute". Good luck, report back with your findings.
25 April 2003, 02:32
<JBelk>
Pyro---

I see a bad wreck in your future. I wouldn't do it. A little wheel chatter on a flimsy spindle will make a big shop real crowded when the wheel comes apart.