One of Us
| No; If the X bolt is like the A bolt, they are not the same. Rem is 1.062x16. |
| | |
one of us
| Browning A bolt are not metric but much finer thread than Remington, I think 30-TPI. I’ve re-barreled many of them but can’t remember exactly the TPI.
John Farner
If you haven't, please join the NRA!
|
| | | Posts: 2947 | Location: Corrales, NM, USA | Registered: 07 February 2001 | 
IP
|
|
one of us
| From "Shooters Forum":
"Browning A-bolt
Old: 15/16 x 20
New: 1' x 32" |
| | |
One of Us
| And they love to loctite those fine threaded Browning barrels on. I usually use heat to get them off. |
| | | Posts: 599 | Location: Weathersfield, VT | Registered: 22 January 2017 |
IP
|
|
One of Us
| Some years ago, Browning advised against removing the barrels due to potential galling...In fact attempting to do so voided warranties. Not sure if that's sill the case |
| | | Posts: 3671 | Location: Phone: (253) 535-0066 / (253) 230-5599, Address: PO Box 822 Spanaway WA 98387 | www.customgunandrifle.com | Registered: 16 April 2013 |
IP
|
|
One of Us
| Thanks for all the info guys! I should probably just leave it alone until it quits shooting. |
| | | Posts: 132 | Location: Huntertown,Indiana | Registered: 11 May 2007 |
IP
|
|
