15 March 2007, 08:18
pdhntr1Pinning a Rem lug?
I know why it's done, I don't know how.
Can someone give me some information on the process??
Thanks.
Jim
15 March 2007, 08:58
pdhntr1Thanks Westpac,
I missed that thread.
Could "bubba" Jim cut the back off a rem barrel I have laying around to make the threaded insert to hold and drill the lug??
Jim
15 March 2007, 10:45
lawndartHe could. The stub should not stick up much, just enough to cut a couple small keyways so you can tighten it like a shotgun choke tube. Not so high so you can get in close with the mill to drill the hole(s).
16 March 2007, 00:18
DwightThere is an alignment tool you can use when switching barrels if the pin idea does not work. The tool is $25 and found at Midway. It works real easy.
16 March 2007, 23:35
pdhntr1Thanks Dwight,
I kinda had my heart set on pinning this one.
But if it doesn't work out that will be the next thing to try.
Jim
17 March 2007, 02:17
J Bennettpdhntr1
Look under gunsmithing on
www.hollandguns.comHe sell the fixture with instructions.
James