Someone with a mill needed.

The Accurate Reloading Forums

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/4331092212

08 July 2015, 04:31

custombolt

Someone with a mill needed.

Can someone here with a 60 degree dovetail cutter and a mill, mill a couple cuts on my mounts in short order? The integrated dovetails on my ZKW-465 are an odd size .642"/16.3 mm and I couldn't find any mounts to fit and the clip is at an angle. So, I would like to have someone mill these CZ-527 mounts a bit and also mill off a nub that is under one of the mounts as well. The difference is approximately .04" So, I think if it can be cut another .03" wider/deeper the clip (on the left) would sit properly, not at an angle as it does now. Sorry about the crude drawing. CB

08 July 2015, 08:10

ted thorn

Check your PM's

________________________________________________
Maker of The Frankenstud Sling Keeper
Proudly made in the USA
Acepting all forms of payment