Go | New | Find | Notify | Tools | Reply |
one of us |
What would be considered the ideal twist rate for the 357 Mag and the 357 Bain & Davis using 158 to 180 grain bullets in a 20 inch barrel? Steve E........ NRA Patron Life Member GOA Life Member North American Hunting Club Life Member USAF Veteran | ||
|
one of us |
Ideal twist rate is usually calculated via Greenhill formula. You can download an app to do the calculation on Z-hat's website. Find the length of the longest bullet you plan to shoot, and plug it in to the formula with the constant for under 2800 fps (there's a different constant for over 2800 fps). Most .357's seem to have 1:14 twists, but when I did the calculation based on the Sierra and Hornady 180's (.752 in and .756 in), I came up with 1:25 inches twist. Some Rossi Puma's apparently have 1:30 inch twists good for only 158 gr and below. HTH, Steve | |||
|
One of Us |
1:14" to 1:16". Check out the PPC revolvers' twist. Regards, Joe __________________________ You can lead a human to logic but you can't make him think. NRA Life since 1976. God bless America! | |||
|
one of us |
skl1 I had a question of, is that the total length of the bullet or just the bearing surface? I'm thinking from your measurements shown that it is the total length of the bullet. Steve E......... NRA Patron Life Member GOA Life Member North American Hunting Club Life Member USAF Veteran | |||
|
one of us |
Total length. Also, remember that Greenhill developed his formula to determine the longest bullet that a existing twist could barely stabilize (he was working with existing navel cannons and the (than) new streamlined projectiles). IOW having a twist rate slightly faster than calculated is not a bad thing. | |||
|
Powered by Social Strata |
Please Wait. Your request is being processed... |
Visit our on-line store for AR Memorabilia