Go | New | Find | Notify | Tools | Reply |
One of Us |
Of what quality are these triggers? I have one for a m98 and would like to know if they are a quality trigger and if they will work for a Zastava action. "I would rather have a German division in front of me than a French one behind me." -- General George S. Patton | ||
|
One of Us |
I have several of these, PH rifles being at one time quite common in NZ. They should fit a Zastava action with the proviso that you would need to shorten the rear action screw spacing tube as the PH triggers sandwich the rear of the trigger between this & the rear of the receiver to hold it in place rather then using setting screw at the front as Timneys etc do. I don't think the PH safety will go into the same slot as on the Zastava though, you'll have to try it. As a trigger they adjust quite well & I find it possible to get a nice crisp release with them. Steve. | |||
|
One of Us |
a very good reply.......if it were me, for the cost, I'd just install a Timney or a Bold trigger. I have a PH trigger.....and it's now replaced with a Timney. /////////////////////////////////////////////////////////////////////////// "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." Winston Churchill | |||
|
One of Us |
I think I am going to go with a Bold. I had discussed it already with someone on 24hourcampfire. He recommended the Bold over the PH. I have been monkeying with it a bit and it just doesn't seem to function right on this action. It will b easier just to have a Bold put on. "I would rather have a German division in front of me than a French one behind me." -- General George S. Patton | |||
|
Powered by Social Strata |
Please Wait. Your request is being processed... |
Visit our on-line store for AR Memorabilia