I have been looking for a stainless steel banded ramp front sight base and also a stainless steel island rear sight base, but I haven't found anything out there.
Are these strictly a hand made proposition?
Mike
Wilderness is my cathedral, and hunting is my prayer.
Posts: 13830 | Location: New England | Registered: 06 June 2003
Originally posted by bcp: Midway has Ruger ones in SS.
Bruce
I like the looks of the ruger front ramps too, that would be a good option.
Another suggestion would be KG Gun Kote. I built a remington a while back in stainless and needed to match the grip cap and bottom metal since they were steel, you couldn't tell the difference in them from the barrel and action. If you don't like the ruger I would go this route and KG the entire gun.
Posts: 328 | Location: Oklahoma | Registered: 20 June 2006
Anybody know the ID on the Ruger Magnum front sight?
The one Midway reviewer said the standard size has a .550" bore but I'm looking for something for a MRC #5 barrel with a nominal .700 OD at the muzzle.
Posts: 1143 | Location: Kodiak | Registered: 01 February 2005
Originally posted by PWS: Anybody know the ID on the Ruger Magnum front sight?
The one Midway reviewer said the standard size has a .550" bore but I'm looking for something for a MRC #5 barrel with a nominal .700 OD at the muzzle.
The largest Ruger stainless one I have goes .745". Another one goes .665".
Posts: 1581 | Location: Either far north Idaho or Hill Country Texas depending upon the weather | Registered: 26 March 2005
Thanks Boxhead!!
