Since the closure of Remington, parts have started to dry up.
I have searched the web looking for an ejector spring and rivet for a 12 gauge 870.
Do you have a spare to sell me?

We might have a spare spring, but the rivets are made of unobtanium. We make ours from discarded buggered scope ring/base screws. Poor man's lathe with drill motor and file. You have to get the steps right as the rivet acts as a double rivet. The larger diameter to the ejector body and the small diameter to the ejector spring. You also need a special mandrel to set the large diameter portion that allows the small portion to slip inside it. I'll check tomorrow and let you know.

PS: If you haven't ground off the rivet that holds the spring on yet, be very careful and remove just enough to free it, then, countersink the spring and you can re-use the rivet.

Bob

Thank you very much

Gun Garage in Siloam Springs AR had rivets made for the 870 ejectors.

J Wisner

Thank you, rivet are on the way!

Checked today and no joy on the ejector spring. Will keep an eye out.

Bob

Thank you, I'll keep looking.

an $8 spring on ebay is $48 plus shipping

Unfortunately, I'm still looking for an ejector spring.
Thanks

Check with Midwest Gun Works

https://www.midwestgunworks.co...ngton-870/parts.html

Numrich schematic doesn't differentiate between standard and magnum, all the same?

quote:

Originally posted by Jim Kobe:
Numrich schematic doesn't differentiate between standard and magnum, all the same?

They are now all 3"

Thanks to a member here, I've got one on the way!

Karma, is a thing.

I have one and it comes with two extra rivets and I think I may even have the riveting punch to go with it and don't need any of it

I got my 870 back from the smith, all is as it should be. Thanks to member here.