I`ve no experiance with this barrel maker,,and if i could get your thoughts,,,opinions,,,the good ,,the bad,,the ugly,,ect.,i`m looking at
the cryoed SS 1.250 at muzzel in 26",,28" if I can get it,,and in 6.5 mm,,,,thanks for your feed back and help,,,,,,,,,,,,,,,,,,,,,,,,Roger 4

Some people don't like them but I have had them do 3 Mauser's so far and have not had any problems. The last one was during that special they were running back earlier in the year. They installed their bolt handle, a rather slim barrel, drilled & tapped and finished it off in a mat blue. It is in 6.5 x 55. The best groups I can get out of it 3/4 to 1 1/4 inches at 100yds. My only complaint is with the bolt handle, I would like a little more back sweep but they only have a jig set up for their bolt handle only. Am I happy with it, you bet, will I use them again, you bet.

Had them rebarrel a shot out 222 Rem 700 for me last fall. They did a fine job, the accuracy is great (1/2" groups with the right load). Used it extensively this spring on ground squirrels. I'm a happy camper.