THE ACCURATERELOADING.COM GUNSMITHING FORUM


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Trouble removing Rem 700 trigger..
 Login/Join
 
one of us
posted
Have you guys ever had trouble removing the retaining pins on a Model 700 trigger? I bought a new SPS about 2 weeks ago and was going to send the trigger off to be adjusted but I cannot get this thing out. Any tricks? Is there something different about these SPS triggers?

Thanks,

Dan
 
Posts: 350 | Location: Austin, TX | Registered: 30 September 2004Reply With Quote
One of Us
Picture of 308Sako
posted Hide Post
Clark, Is the bolt stop in the way? You are right, this should be one of the easier things to do...






Member NRA, SCI- Life #358 28+ years now!
DRSS, double owner-shooter since 1983, O/U .30-06 Browning Continental set.
 
Posts: 3611 | Location: LV NV | Registered: 22 October 2002Reply With Quote
One of Us
posted Hide Post
The pins only come out in one direction. The pin holes have a swadge on one end to keep them snug when installed. Remove the rear pin, first, so that you can remove the bolt stop. That allows the front pin to be removed.
 
Posts: 226 | Registered: 07 January 2005Reply With Quote
one of us
posted Hide Post
I'm following the directions right off of the triggersmith website so I don't think I'm doing anything wrong.
 
Posts: 350 | Location: Austin, TX | Registered: 30 September 2004Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia