Installation help putting a Decellerator pad on a McM stock

The Accurate Reloading Forums

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/141105036

27 February 2007, 01:15

safarihunter

Installation help putting a Decellerator pad on a McM stock

I've got a McMillan Featherweight stock from a WinLite rifle that I want to put a Decellerator pad on.

I have installer Decellerator pads on wood stocks but not McM's. I really don't want to cut the stock because I don't have the right saw to do the job properly and don't want to mess up the fiberglass.

I was looking at the factory pad and noticed the hard plate that the factory pad is bonded to. I can cut the rubber without a problem. Would there be a problem with installing the Decellerator pad to that base plate?

I appreciate any knowledgeable help.

27 February 2007, 05:51

Toomany Tools

If I'm not mistaken those pads are glued on--no screws. I do not know for sure though. I'd give them a call and ask them. Nice folks, just way too slow to deliver for me.

27 February 2007, 07:45

ramrod340

quote:
If I'm not mistaken those pads are glued on--no screws

I believe they are as well. I epoxy mine on even on wood now days. No cuts.